INSTALLATION INSTRUCTIONS FOR HUNTER CEILING FANS TYPE 3
Step 7: Finish Hanging Fan
A. Remove the fan from the ceiling plate hook. Make sure you do not break any wire connections. The canopy has (3) suspension flanges located on top. See Figure 7. The ceiling plate has (3) mating slots. See Figure 7A.
B. Lift the fan and position the (3) flanges in the canopy into the (3) mating slots in the ceiling plate. Lift the fan until it is free to rotate in either direction. Rotate the fan until the (3) holes in the canopy line up with the (3) mating holes in the ceiling plate. Using (3) 10-32 x 1/2'' long Phillips round head screws, secure the canopy to the ceiling plate.
CAUTION: Check and make sure no wires are caught between the canopy and ceiling plate.
CAUTION: Failure to properly tighten the (3) screws could result in the fan falling.
NOTE: For the ball hanging fan configuration make sure the (2) grooves in the ball are engaged with the (2) tabs in the canopy. Failure to do so could result in the fan falling. See Figure 5C.
