1. Nothing happens; fan does not move.*

*NOTE: If blades will not turn by hand, contact your nearest service representative.

1. Power turned off or fuse blown.
2. Loose wire connections or wrong connections.
3. Pull chain switch not "ON".

1. Turn power on or replace fuse.
2. Loosen canopy. Check all connections. (Turn power off while checking.)
3. Pull switch chain.

1. Blade brackets loosely screwed to motor.
2. Blade screwed loosely to blade bracket.
3. Blade cracked.
4. Non-Approved speed control being used.

1. Tighten screws until snug.
2. Tighten screws.
3. Replace all blades
4. Change to approved speed control.

3. Excessive wobbling.

When switching from medium to low speed, you may notice some fan wobble. When fan speed stabilizes at low speed, wobble will disappear.

1. Blade brackets not attached at proper locations.
2. Unbalanced blades.
3. Fan too close to vaulted ceiling.
4. Loose blades or blade brackets.
5. Fan not secure on hanger assembly.

1. Carefully review Step 8.
2. Use blade balancing kit. (See Step 8C.)
3. Lower or move fan.
4. Tighten all screws.
5. Turn power off. Support fan very carefully. Loosen canopy and hang correctly.