INSTALLATION INSTRUCTIONS FOR HUNTER CEILING FAN TYPE 2
Step 10: Install Glass Globe
A. Before installing the globe, determine which of the (2) pull chains is used to control the fan. Located on the bottom of the light fixture, next to the fan pull chain switch is a label marked "fan". After installing the globe, pull this chain to control the fan. Pull the other chain to control the light. After the globe and finial have been installed, attach the wood balls with the exten- sion chains to the ends of the fan and light pull chains using the breakaway connector attached to the end of the extension chains. See Figure 10C.
B. Locate the (3) pins at the bottom of the (3) flanges on the plastic spacer. See Figure 10.
Align the (3) pins with the (3) small clearance holes in the metal plate at the bottom of the globe assembly. See Figure 10A. Make certain the (2) pull chains are aligned with the (2) larger out- board holes in the metal plate. Guide the threaded tube and both chains through the larger holes in the metal plate. See Figure 10A. Lift the globe until the metal plate in the bottom of the globe bottoms out against the plastic spacer with the (3) pins sticking through the small holes in the metal plate.
Keeping the globe in position, place the large flat washer over the threaded tube and against the bottom of the globe. Thread the assembly nut onto the threaded tube, running it up tight against the bottom of the washer. Tighten the nut very securely. See Figure 10A.
NOTE: Check and make certain the metal plate in the bottom of the globe is tight against the plastic spacer. Assemble the finial to the bottom of the light fixture by guiding the (2) pull chains and threaded tube through the (3) openings in the finial. See Figure 10B.
NOTE: If the reversing switch plastic pull does not extend below the threaded tube, tap on the threaded tube and the plastic pull should drop down into the proper position.
The breakaway connector is designed to separate from the chain at a predetermined force. If a separation occurs, simply reinsert the connector. It can be reused again and again.
