INSTALLATION INSTRUCTIONS FOR HUNTER CEILING FAN TYPE 2
Step 9: Aligning the Fixture Fitter
A. Looking up at the bottom of the fan trim. Locate the raised arrow on the bottom of the trim. See Figure 8. Before proceeding with the next step make sure you've located the arrow.
NOTE: You may have to rotate the fan blades in order to see the arrow.
B. The (8) sides of the fitter must be aligned with the matching (8) sides of the fan trim. To orient the fitter locate the (3) arrow shaped holes near the outer edges of the fitter. See Figure 9.
Select the arrow which has a screw hole directly behind it, and align this arrow with the arrow in the trim. See Figure 9.
Step 9A: Installing the Fixture Fitter
Thread the upper plug connector from the motor through the large hole in the center of the fitter. See Figure 9A.
Check the (3) elongated slots in the top of the fitter to see if they are aligned with the (3) mating screw holes in the fitter mounting plate. If any of the screw holes in the mounting plate are covered by the fitter, rotate the fitter ninety degrees either direction to allow access to the (3) mounting holes in the mounting plate. See Figure 9B.
Assemble the fitter to the fitter mounting plate using (3) 3/8" long Phillips round head screws with lockwashers. See Figure 9A. Tighten the (3) screws securely.
CAUTION: Failure to securely tighten the (3) assembly screws could result in the light fixture falling.
Step 9B. Attaching the Light Fixture
Plug the upper and lower plug connectors together. See Figure 9C. The connectors are keyed and will only go together one way.
Before assembling the light fixture to the fixture fitter locate the arrow shaped hole positioned directly behind one of the (3) screw clearance holes on the outside flange of the light fixture. See Figure 9D.
Align the arrow in the light fixture with the arrows previously used to align the fan trim and fixture fitter. See Figure 9D. Attach the light fixture to the fixture fitter using (3) 3/8" long Phillips round head screws with lockwashers. See Figure 9C.
Tighten the screws securely.
CAUTION: Failure to securely tighten the (3) assembly screws could result in the light fixture falling.
Install (2) candelabra base lamps. Refer to maximum wattage label on light fixture for maximum lamp wattage.
