INSTALLATION INSTRUCTIONS FOR HUNTER CEILING FAN TYPE 2
Step 8: Fan Blade Assembly, Installation, and Balancing
A. Slide wood blade through slot in belly band and line up the (2) holes in the blade with the rubber grommets in the blade bracket. Insert rubber grommets into the (2) holes in the blade and assemble the blade to the blade bracket using the shoulder screws provided in sack parts. When properly assembled, the end of the blade grommets will fit inside the bracket grommet. Snug the shoulder screws to prevent vibration and wobble when the fan is operating. See Figure 7.
NOTE: When the screws are tight the blades may feel loose. This is normal when using grommets and will not be a problem.
B. Repeat the step shown above until all the blades are securely attached.
C. A blade balancing kit has been provided with your fan. Should the fan wobble in operation, you may use this kit to correct the balance per the instructions supplied with the kit.
NOTE: After installing all the blades, check the (10) blade bracket assembly screws which attach the brackets to the motor. Make certain they are tight. See Figure 7. Failure to tighten these screws will result in noise and wobble when the fan is operating.
