1. Nothing happens. Fan does not move.

*Note: If blades will not turn by hand, contact your nearest service representative.

1. Power turned off or fuse blown.
2. Loose wire connections or wrong connections.
3. Motor reversing switch not engaged.
4. Pull chain switch not "on."

1. Turn power on or replace fuse.
2. Loosen canopy, check all connections (turn power off while checking).
3. Push switch firmly to one side or the other.
4. Pull switch chain.

1. Blade brackets loosely screwed to motor.
2. Blade screwed loosely to blade bracket.
3. Blade cracked.
4. Non-approved speed control being used.
5. Globe is vibrating and emitting noise.

1. Tighten screws until snug.
2. Tighten screws.
3. Replace entire set of blades.
4. Change to approved speed control.
5. Re-adjust 3 globe mounting screws.

3. Excessive wobbling.

When switching from medium to low speed, you may notice some fan wobble. When fan speed stabilizes at low speed, wobble will disappear.

1. Unbalanced blades.
2. Fan too close to vaulted ceiling.
3. Loose blades or blade brackets.
4. Fan not secure on hanger assembly.

1. Use balancing kit.
2. Lower or move fan.
3. Tighten all screws.
4. Turn power off, support fan very carefully, loosen canopy, and hang correctly.