Installation Instructions For Type 2 Hunter Ceiling Fan With Light
Step 7: Finish Fan Assembly
A. The ceiling plate has four (4) mounting screw holes located on the ends. Install two (2) #10-32 x 1/2" Phillips pan head screws halfway in the two holes that line up with the mating slots on the canopy as shown in Figure 10.
Remove the fan from the ceiling plate hook, make sure not to break any wire connections, line up the two slots in the canopy with the screws, and push the canopy upwards and turn it clockwise to hang the canopy from these screws.
B. Insert the remaining two mounting screws into the holes in the canopy and screw in the ceiling plate. Tighten all screws securely.
Caution: Failure to securely assemble the canopy screws could result in the fan falling.
Note: For the hanging fan configuration, rotate fan until groove in ball is positioned over tab in canopy. Make certain groove and tab are engaged before running fan. See Figure 11. Failure to do this could result in the fan falling.
C. Install foam decal (if supplied) by removing peel-off backing from adhesive "dots" and placing decal over canopy and pressing it onto the ceiling. See Figure 12.
