Hunter Fan Company Remote Ceiling Fan & Light Control

 

Troubleshooting
Symptom Possible Causes Solution
1. No functions operate.
  1. Main Power not restored.
  2. Fan pull chain not set to HIGH.
  3. Light pull chain not set to ON.
  4. Receiver wiring incorrect.
  5. Transmitter and receiver jumper switches do not match.
  6. Battery too weak.
  1. Replace fuse. Turn ON circuit breaker. Turn ON wall switch.
  2. Turn OFF power at wall switch or main electric panel. Set fan to HIGH speed.
  3. Set light kit to ON.
  4. Verify wiring connections.
  5. Set transmitter and receiver to same jumper switch setting.
  6. Replace with new, alkaline battery.
2. Operates only at close range.
  1. Signal blocked from reaching receiver.
  2. Battery too weak.
  1. Extend antenna into ceiling box, or move it for better reception.
  2. Replace with new, alkaline battery.
3. Inconsistent operation.
  1. Signal partially blocked from reaching receiver.
  2. RF interference.
  3. Continuing RF interference.
  1. Extend antenna into ceiling box, or move it for better reception.
  2. Turn OFF wall switch for 5 seconds, then turn back ON.
  3. Change dip switch settings to a different code in both Transmitter and Receiver.