Hunter Fan Company Remote Ceiling Fan & Light Control
Receiver Installation:
1. Disconnect the power to the ceiling fan and light kit at the main electric panel. Remove fuse or move circuit breaker to the OFF position. Turn off wall switch.
2. IMPORTANT! Before installing this control, change the factory default jumper switch settings to your own unique code. Refer to Figure 1. Using small pliers or tweezers, pull out one or more of the three jumper switches by clamping on the small metal strip. Place the jumper switches in the desire spots. Be sure the jumper switch positions of the transmitter and receiver match, or the ceiling fan will not function. Select different combinations of jumper switches to prevent misoperation due to other remote control fans, garage door openers, etc.
3. Install the ceiling fan according to its instructions, up to the point of making the electrical connections.
Note: When installing the receiver, be sure to cut the fan leadwires to leave 6 1/2" extended outside of the hanger pipe. Strip the fan leadwires to leave no more than 5/16" bare wire exposed.
4. Use the two large wire nuts supplied to connect the receiver and house wiring, then use the three small wire nuts supplied to connect the receiver and ceiling fan wiring. Refer to the Wiring Diagram in Figure 2.
5. Install receiver as shown in Figure 3. Line up the slots on the receiver with the ceiling plate. Be sure to push wire connections from the ceiling back up through the hole in the ceiling plate. Wires attaching from the ceiling plate to the fan should be placed inside the canopy under the receiver. Once the receiver is installed, continue with the appropriate instructions from the fan installation manual to finish installing the fan.
