INSTALLATION INSTRUCTIONS FOR OUTDOOR USE HUNTER CEILING FANS USING INSTALLER'S CHOICE MOUNTINGS
Step 7: Finish Fan Assembly
A. The ceiling plate has (3) mounting screw holes located on the side. Lift up the rubber cover and install (2) #10-32 X 1/2" Phillips round head screws halfway into two of these holes. See Figure 6.
Remove the fan from the ceiling plate hook. Make sure not to break any wire connections. The canopy has (2) mating slots and (1) mating hole. See Figure 6.
B. Position (2) slots in canopy directly under and in line with (2) mounting screws in ceiling plate. Lift fan until ceiling plate mounting screws are seated in bottom of slots in canopy. Rotate fan counterclockwise until both mounting screws drop into slot recesses. Tighten screws securely. Install third screw into mounting hole.
CAUTION: Failure to securely assemble the canopy screws could result in the fan falling.
NOTE: For the hanging fan configuration, rotate fan until groove in ball is positioned over tab in canopy. Make certain groove and tab are engaged before running fan. See Figure 7. Failure to do this could result in the fan falling.
