A. Connect electrical supply leads to the leads from the motor, using approved connectors.

1. Connect black electrical supply lead to the black motor lead and the black with white stripe motor lead (see note).

2. Connect the white electrical supply lead to the white motor lead.

3. Connect the ground wire to the green leads.

NOTE: If a separate wall switch will be used to control a lighting accessory, connect the black wire with a white stripe to the wall switch lead, following wiring instructions included with the accessory. The wall switch must be acceptable for use as a generaluse switch.

CAUTION: No bare wire or wire strands should be visible after making connections.

B. After making the wire connections, all wires must be pushed back up into the outlet box. The splices should be turned upward. The wires should be spread apart with the white and the green wires on one side of the outlet box, and the black and black/white wires on the other side of the box.

NOTE: If the wires are not pushed up into the outlet box they could strike the motor when it operates.