INSTALLATION INSTRUCTIONS FOR HUNTER LOW PROFILE CEILING FANS
Step 7: Finish Fan Assembly
Step 7: Finish Fan Assembly
A. Using two 8-32 by approximately 5/8" long screws, from sack parts, thread the plastic hanger locking screws into the back of the hanger bracket. See Figure 6. The screws should be driven all the way into the bracket and tightened. The screws are located just above the plastic hanger and prevent the motor from twisting when the blades are assembled.

Check and make sure all wiring is tucked up into the outlet box.
B. Place the fan housing over the motor assembly and fasten the housing to the ceiling plate using the four screws provided (two each side). See Figure 6A.

Check and make sure the motor clears the opening in the bottom of the housing.