A. Install the (4) rubber bushings into the top of the ceiling plate by inserting small side of the bushing into the four holes in the ceiling plate. See Figures 4 and 4A.

B. Thread the lead wires through the opening in the top of the ceiling plate and through the opening in the side of the hanger bracket. See Figure 4B.

Using the two center slots, install the ceiling plate to the 2 x 4 brace which supports the outlet box. Use (2) #10 woodscrews 3" long and (2) flatwashers for mounting. Drill (2) pilot holes for the mounting screws 9/64" diameter. See Figure 4B.

NOTE: When attaching ceiling plate to the outlet box support, make certain bushings remain in place.

NOTE: Tighten the ceiling plate mounting screws only enough to provide slight compression of the bushings. Do not over-tighten.