INSTALLING LIGHT FIXTURE
INSTALLING INCLUDED SINGLEGLOBE LIGHT FIXTURE
1. Remove the plug cap from the lower switch housing. Figure 9a
Note: Do not discard the plug cap. You will need this if you remove the light fixture in the future.
2. Locate the two wires in the lower switch housing labeled "Connect Light Here" or "For Light Use". One will be white, the other black/ white. Unscrew the wire nuts counterclockwise to expose the bare metal leads.
3. Locate the white wire and the black wire coming from the light fixture.
4. Thread the two wires from the light fixture through the center hole in the lower switch housing.
5. Screw the fixture into the lower switch housing. Thread the lockwasher and nut provided over the wires. Making sure the light fixture mounting screw holes are aligned; hold the light fixture and tighten the nut on the inside of the lower switch housing. Insert and tighten the two #6-32 sems light fixture mounting screws.
6. Connect the black wire from the light fixture to the black/white wire from the lower switch housing. See Figure 9b.
Connect the white wire from the light fixture to the white wire from the lower switch housing. See Figure 9b.
To fasten the wires, twist the two bare leads together. Place a wire nut over the intertwined length of wire and twist clockwise until tight.
CAUTION Be sure no bare wire or wire strands are visible after making connections.
7. Connect the upper plug connector from the motor to the lower plug connector in the lower switch housing assembly. See Figure 8e.
Note: Both plug connectors are polarized and will only fit together one way. Make sure that both connectors are properly aligned before connecting them together. Incorrect connection could cause improper operation and damage to the product.
8. Place the lower switch housing assembly over the upper switch housing. Align the side screw holes in the upper and lower switch housings. Attach the lower switch housing to the upper switch housing with three #6-32 x 3/8" housing assembly screws. See Figure 8e.
