INSTALLING LIGHT FIXTURE

AURORA, TIFFANY, AND SPOTLIGHT FIXTURES

Note: Sub-step 1 applies to all light fixtures. Sub-steps 2-7 apply to Tiffany and Aurora light fixtures. Refer to Figure 9e.

1. Install bulbs.

2. Thread the fan switch pull chain through the hole in the metal disk.

3. Place globe on pipe until flush against metal disk.

4. Thread the light switch pull chain through the large center opening of the globe.

5. Thread the fan switch pull chain through the small center opening in the globe.

6. Place the cover plate up against the underside of the globe. Pass light and fan switch pull chains through the appropriate holes.

7. Thread the light switch pull chain 4 through the finial and screw the cap onto the pipe end until tight.