Use the Step 3 instructions for the type of mounting you have selected: standard, angle, or flush.

STANDARD AND ANGLE MOUNTING

For Standard 8-foot Ceilings and Higher

1. Insert the pipe through the canopy as shown in Figure 3a.

Feed wires from the fan through the pipe.

2. Screw pipe into fan assembly until tight.

IMPORTANT! Tighten pipe setscrew as shown in Figure 3a.

CAUTION The pipe has a special coating on the threads. Do not remove this coating; the coating prevents the pipe from unscrewing. Once assembled, do not remove the pipe.

FLUSH MOUNTING

For Low Ceilings

1. Fit the canopy over the motor hanger adapter as shown in Figure 3b. Make sure the canopy fits snugly against the fan assembly with no space between the pieces.

2. You will find a large assembly washer included with the fan. Place the washer over the adapter and canopy as shown in Figure 3b.

3. Position the slots in the assembly washer over the threaded holes in the adapter as shown in Figure 3c.

4. Attach the canopy tightly to the fan assembly with three #8-32 assembly screws and lockwashers as shown in Figure 3d.