![]() |
|||||||
| You are here: Home > Help Center > Ceiling Fan Info > Manuals > Installation and Operation Manual for Hunter Ceiling Fans > Step Four |
Installation and Operation Manual For Hunter Ceiling FansSTEP 4 - WIRING THE FAN 1. Disconnect the power by turning off the circuit breakers to the outlet box and associated wall switch location. 2. Tilt and hang the assembled fan from the ceiling plate hooks. Slip two rectangular canopy slots over ceiling plate hooks as shown in Figures 4a and 4b.
Note: To hang the fan you must tilt the canopy to an almost vertical position so the canopy slots come down over the ceiling plate hooks. 3. You can use either one or two wall switches to control the fan and/or lights separately. Use connection 1 on page 13 to
Use connection 2 on Figure 4c if there
is no separate wall switch
power wire for the light fixture.
Note: Wall switches not included. 4. Connect the wires as shown in Figure 4c. To connect the wires, twist the bare metal leads together. Place a wire nut over the intertwined length of wire and twist clockwise until tight as shown. CAUTION Be sure no bare wire or wire strands are visible after making connections. 5. Separate the connected wires by placing the green and white wires on one side of the outlet box and the black and the black/white wires on the other side of the outlet box. 6. Turn the connectors upward. Push the wires gently into the outlet box.
|
|
|||||||||||||||||||||||||||||||||||||
Products:
Hunter
ceiling fans ® | Disposals | Air
Cleaners | Humidifiers
Site Services:
View Cart
| Ceiling
Fan Info | Policies
| Contact
Copyright © 2004 Below
Cost Appliances
Hunter is a registered trade mark of the Hunter Fan Company
Below Cost Appliances is proud
to be an authorized agent for KitchenAid products
KitchenAid has granted Below Cost Appliances permission to use trademarks and copyrighted
material for limited purposes