Installation and Operation Manual for Installers Choice® Ceiling Fans

STEP 6 - HANGING THE FAN

Sub-steps 1 and 2 apply to Flush, Standard, and Angle mounting.
Sub-step 3 applies to Standard and Angle mounting only.

1. Swing the fan up so as to align the canopy screw holes with the mounting holes on the ceiling plate. Refer to Figure 6a.

2. Install and tighten the two #10-32 x 1/2" mounting screws.

3. For Standard and Angle Mounting only:

In addition to sub-steps 1 and 2, lift the fan housing towards the ceiling and rotate the fan until each canopy tab engages a groove in the hanger ball as shown in Figure 6b.

Note: If the tabs are already engaged, do not rotate.

WARNING Failure to complete sub-steps 1 through 3 could cause fan to fall. (Sub-step 3 not applicable for flush mounting.)