Installation and Operation Manual for Installers Choice® Ceiling Fans

STEP 4 - ASSEMBLING THE FAN

Use the Step 4 instructions for the type of mounting you have selected: standard, angle, or flush.

STANDARD AND ANGLE MOUNTING

For Standard 8-foot Ceilings and Higher

1. Insert the pipe through the canopy as shown in Figure 4a. Feed wires from the fan through the pipe.

2. Screw pipe into fan assembly until tight.

IMPORTANT! Tighten pipe setscrew as shown in Figure 4a.

CAUTION The pipe has a special coating on the threads. Do not remove this coating; the coating prevents the pipe from unscrewing. Once assembled, do not remove the pipe.

FLUSH MOUNTING

For Low Ceilings

1. Position the three rubber spacers over the threaded holes in the motor adapter as shown in Figure 4b

2. Fit the canopy over the motor hanger adapter as shown in Figure 4c. Make sure the canopy fits snugly against the fan assembly with no space between the pieces.

3. You will find a large assembly washer included with the fan. Place the washer over the adapter and canopy as shown in Figure 4d.

4. Position the slots in the assembly washer over the threaded holes in the adapter as shown in Figure 4c.

NOTE: Upon completing step 3, the slots in the assembly washer, the rubber spacers and the threaded holes in the adapter should be aligned.

5. Insert the three assembly screws and lockwashers through the spacers and into the adapter.

6. Attach the canopy tightly to the fan assembly with three assembly screws and lockwashers as shown in Figure 4d.