Installation and Operation Manual for Installers Choice® Ceiling Fans

STEP 5 - WIRING THE FAN

1. Disconnect the power by turning off the circuit breakers to the outlet box and associated wall switch location.

2. Tilt and hang the assembled fan from the ceiling plate hooks. Slip two rectangular canopy slots over ceiling plate hooks as shown in Figures 5a and 5b.

Note: To hang the fan you must tilt the canopy to an almost vertical position so the canopy slots come down over the ceiling plate hooks.

3. You can use either one or two wall switches to control the fan and/or lights separately. Use connection 1 below to

4. Connect the wires as shown in Figure 5c. To connect the wires, twist the bare metal leads together. Place a wire nut over the intertwined length of wire and twist clockwise until tight as shown.

CAUTION Be sure no bare wire or wire strands are visible after making connections.

5. Separate the connected wires by placing the green and white wires on one side of the outlet box and the black and the black/white wires on the other side of the outlet box.

6. Turn the connectors upward. Push the wires gently into the outlet box.