1. Remove rocker style wallplate (not included) to expose the wall wiring. Disconnect the existing switch and remove from the electrical box.

2. If 4 wires are visible, connect each black wire to an All-FanT black black wire. If 2 wires are visible, connect each to an All-FanT lead. Use 2 of the large wire nuts supplied to make the connections. Refer to Figure 2.

3. If a ground wire is provided in your electrical box, attach it to the ground screw near the bottom of the mounting plate.

4. Gently push wires and wall control into the electrical box. Attach the All-FanT control to the switch box with the two screws provided.

5. Verify that the master switch is in the OFF Position. Press inward on each side of the wall control to remove face cover. Set the dip switches to match the dip switches in the receiver. Install a 12 volt alkaline battery (A23, MN21, or equivalent). Replace the face cover.

Select your own unique code, being sure settings match in the transmitter and receiver.